Preparations
Preparing the remote controller
Installing the remote controller batteries
1 Remove the battery compartment cover by pressing and sliding it away from the remote controller unit.
2 Insert two AA (R6 or
Carefully follow the polarity diagram (posi- tive + and negative - symbols) inside the battery compartment.
3 Replace the compartment cover.
Notes
Using the remote controller
Point the remote controller toward the remote control sensor.
The STANDBY indicator lights up when the unit receives a signal from the remote controller.
Remote control sensor
30˚ |
| |
| 30˚ | m |
|
| |
|
| 5 |
|
| Aboutfeet) |
| Control range | (16 |
|
|
Notes
•Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller.
•Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference.
•Do not put any object such as a book on the remote controller. The buttons of the remote controller may be pressed by mistake and drain the batteries.
•Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote controller operation.
•If there is any obstacle between the remote con- troller and the remote control sensor, the re- mote controller will not operate.
Preparations Connections
•Do not mix new batteries with old batteries or different kinds of batteries.
•To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time.
•Remove dead batteries immediately to avoid damage from corrosion. If the remote control- ler doesn’t operate smoothly, replace both the batteries at the same time.
•The life of the batteries supplied is about six months but this will vary depending on usage.
17