17

Connecting the POWER

The DV-C503 is shipped with the main power (POWER) switch in the
on position ( ON). When the power cord is plugged in for the first
time, the DV-C503 will automatically enter the standby mode and the
STANDBY indicator will light (same condition after step 2 below).
Turning on
2Press POWER to switch

on the main power.

The DVD Changer enters standby mode.
The STANDBY indicator lights up.
Notes
•The buttons on the remote controller do not operate if
the POWER switch is set to OFF.
•To switch off the main power, press POWER again.
3Press STANDBY/ON

on the DVD Changer or

remote controller.

The DVD Changer turns on and the STANDBY
indicator turns off. It takes several seconds to read
the disc in the disc tray.
Notes
•
You can turn on the DVD Changer by pressing 0 or £/8.
•
To put the DVD Changer in the standby mode, press
STANDBY/ON on the DVD Changer, or remote
controller. Be sure to set the volume to minimum before
putting the DVD Changer in the standby mode for the
next use to avoid sudden loud sound reproduction.
•
While the STANDBY indicator lights up, the DVD
Changer can receive signals from the remote controller.
However, if you press POWER on the DVD Changer
to switch off the main power, the remote controller
cannot be used to turn on the DVD Changer.
•Setting the STANDBY button to standby does not shut
off the power completely.
Notes
•Make sure that all appropriate connections have been completed
as described on pages 14 to 16.
•Turning on the DVD Changer may cause a momentary power
surge, which might interfere with other electrical equipment such
as computers. To prevent interference, use a wall outlet on a
different circuit.
STANDBY/ON
POWER STANDBY/ON
STANDBY indicator
1Plug the power cord

into the power outlet on

the wall.