■DTS Out

This player is capable of outputting DTS digital audio for DVDs recorded in DTS. When this player is connected to an AV component that has a built-in DTS decoder, select [DTS]. If your system is not equipped to decode DTS, select [Off]. Refer to the operating instructions supplied with your audio components if you are unsure about compatibility with DTS.

Audio Video1 V2 Language General

Audio DRC — Off

Dolby Digital Out — Dolby Digital

DTS Out

Off

96kHz PCM Out

DTS

MPEG Out — MPEG 3PCM

Change DTS output mode

 

 

Move

SETUP Exit

Settings: Off (Factory setting)

DTS

Note

If you have made digital audio connections to component(s) not equipped to decode the DTS digital bitstream, be sure to select [Off]. If a DTS signal is output without decoding, the output is digital noise that could potentially cause damage to your speakers.

■96 kHz PCM Out

This player is capable of outputting digital signals with a sampling frequency of 96 kHz. If you have made connections to a component capable of processing this signal rate, select [96 kHz] for the signal to be output as is. As some components are incapable of processing digital signal input with sampling rates of 96 kHz, selecting [96 kHz 3 48 kHz] compresses the signal to a standard signal with a sampling rate of 48 kHz.

Audio Video1 V2 Language General

Audio DRC — Off

Dolby Digital Out — Dolby Digital

DTS Out — Off

96kHz PCM Out

96kHz 348kHz

MPEG Out

96kHz

Change 96kHz output mode

 

 

Move

SETUP Exit

Settings: 96 kHz 3 48 kHz (Factory setting )

96 kHz

Note

On DVDs that contain copy protection, the 96 kHz signal may only be output from the analog audio jacks.

■MPEG Out

This player is capable of outputting the MPEG digital bitstream. When the player is connected to an AV component that has a built-in MPEG decoder, select the [MPEG] setting. Otherwise, select [MPEG 3 PCM] to convert the digital signal to the PCM signal, the digital signal output from a CD.

Audio Video1 V2 Language General

Audio DRC — Off

Dolby Digital Out — Dolby Digital

DTS Out — Off

96kHz PCM Out — MPEG

MPEG Out MPEG 3PCM

Change MPEG audio output mode

Move

SETUP Exit

Settings: MPEG

MPEG 3 PCM (Factory setting)

■Digital Out Expert

Depending on your preferences and the type of connections made, you may opt not to have the digital audio signal output at all. When this setting is set to [Off] there is no signal output from the digital audio output jacks.

Make changes to the [Digital Out] setting in the Setup screen Audio menu in the [Expert] menu mode (page 39).

Audio Video1 V2 Language General

Audio DRC — Off

Dolby Digital Out — Dolby Digital

DTS Out — Off

96kHz PCM Out — 96kHz 348kHz MPEG Out — MPEG 3PCM

Digital Out On

Off

Move

SETUP Exit

Settings: On (Digital bitstream is output) (Factory setting) Off (Digital bitstream is not output)

41