Front & Rear Panels
Front Panel
a b c | d | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
a POWER switch | c STANDBY indicator |
This is the main power switch. When set to OFF, the amplifier is completely shutdown. It must be set to ON to set the amplifier to On or Standby.
bON/STANDBY button
This button is used to set the amplifier to On or Standby.
Note:
If you wish to turn on the amplifier again after it is turned off, wait for several seconds.
The amplifier is in standby state and waits for instruction signal from the 12V TRIGGER IN ter- minal.
dON indicator
The main power of the amplifier is turned on and you can play and enjoy an input source.
Notes:
•If the POWER switch is pressed and both of the ON and STANDBY indicators do not light, check that the power cord is properly connected. If the indictors still do not light, turn off the amplifier, disconnect the power cord from wall outlet, and contact your Onkyo dealer.
•If the STANDBY indicator flashes red, the protection circuitry of the amplifier has activated. The protection circuitry activates if a problem such as a speaker cable shorting or excessive temperature occurs. Turn off the amplifier, remove the cause of the problem, and then turn it back on. If the problem is still not solved, turn off the amplifier, disconnect the power cord from wall outlet, and contact your Onkyo dealer.
8
