Other Information
Troubleshooting
If you have any problems with the unit, please check the troubleshooting table below first. For any problems not covered in the table, please consult your nearest ONKYO authorized service center.
Symptom | Cause | Remedy |
|
The unit doesn’t turn on. | The AC power cord is not fully in- | Insert the AC power cord (mains lead) | |
| serted into the wall outlet. | plug into the wall outlet (the mains) | |
|
| securely. | |
Sound is reproduced from neither left or right speaker.
• The wire of the speaker cord is | • Check the speaker connections (see | ||
| touching the other jacks, connec- |
| page 14). |
| tors, or metal parts. | • | Adjust the volume level (see page |
• | The volume level is turned down | ||
| to the minimum. |
| 19). |
• | The sound is muted with the mut- | • Press MUTING button on the re- | |
| ing function. |
| mote controller to restore the sound |
|
|
| (see page 21). |
• | The headphones are connected to | • | Turn down the volume level first, |
| the PHONES jack. |
| then disconnect the headphones. |
|
|
| Then, readjust the volume level. |
Sound is reproduced from | • | The speaker cord is not connected | • Check the speaker connections (see | |
only one speaker. |
| properly or firmly, or is discon- | page 14). | |
|
| nected. | • Adjust the sound balance (see page | |
| • | The sound is unbalanced between | ||
|
| the left and right speakers. | 20). |
|
|
|
|
|
|
No sound is reproduced | • | The volume level is turned down | • Adjust the volume to the proper | |
when the |
| to the minimum. | level when you set the timer (see | |
operates. |
|
| page 19). | |
| • The muting function was on when | • Press MUTING button on the re- | ||
|
| you set the timer. | mote controller to restore the sound | |
|
|
| (see page 21) before you set the | |
|
|
| timer. |
|
The remote control doesn’t • | The batteries in the remote control- |
operate. | ler are dead. |
• | The remote controller is out of the |
| control range. |
• There is some obstruction between the remote controller and the unit.
•Replace the batteries with new ones (see page 17).
•Operate the remote controller within the control range (see page 17).
•Try to operate the remote control- ler from a different angle, or remove the obstruction.
Information Other Operation Preparations Connections using Before
23