Onkyo HTP-240, SKS-HT240 instruction manual Getting to know Your Speaker Package, Subwoofer SKW-240

HTP-240.fm Page 5 Thursday, April 7, 2005 4:36 PM

Getting to know Your Speaker Package

Subwoofer (SKW-240)

■Front

1

■Rear

Front, Center & Surround Speakers (SKF-240F, SKC-240C, SKM-240S, SKB-240)

3

2

1

OUTPUT

LEVEL

MIN MAX

2

LINE

INPUT

	POWER
ON	OFF

3 4

To AC outlet

4

ASTANDBY/ON indicator

Red: Subwoofer in standby mode

Green: Subwoofer on

With the Auto Standby function, the SKW-240 automatically turns on when an input signal is detected in Standby mode. When there’s no input signal for a while, the SKW-240 automatically enters Standby mode.

BOUTPUT LEVEL control

This control is used to adjust the volume of the sub- woofer.

CLINE INPUT

This RCA input should be connected to the sub- woofer preout on your DR-S2.2 DVD Receiver, amp, or other receiver with supplied RCA cable.

DPOWER switch (not North American model)

To turn on the SKW-240, set the POWER switch to the ON position (the indicator lights up).

To turn off the SKW-240, set the POWER switch to the OFF position (the indicator goes out).

Note:

The Auto Standby function turns the subwoofer on when the input signal exceeds a certain level. If the Auto Standby function does not work reliably, try slightly increasing or decreasing the subwoofer output level on your receiver or amp.

1Speaker terminals

These push terminals are for connecting the speaker to your DR-S2.2 DVD Receiver, amp, or other receiver with the supplied speaker cables. The sup- plied speaker cables are color-coded for easy identi- fication. Simply connect each cable to the same- colored positive speaker terminal.

2Keyhole slots

These keyhole slots can be used to wall-mount the speaker either horizontally or vertically.

3Speaker mount/bracket inserts

These threaded inserts can be used to attach the speaker either horizontally or vertically to a speaker mount or bracket.

Note:

Use commercially available M5 machine screws (1/ 4-inch screws for North American model) to attach the speaker to a speaker mount or bracket.

4Base inserts (other than center speaker)

These threaded inserts can be used to mount the speaker on the supplied base (screws included).

5