Precautions
1.Warranty card
You can find the serial number on the rear panel of this unit. In case of warranty claim, please report this number.
2.Recording Copyright
Recording of copyrighted material for other than personal use is illegal without permission of the copyright holder.
3.AC Fuse
The fuse is located inside the chassis and is not user- servicable.
If power does not come on, contact your Onkyo authorized service station.
4.Care
From time to time you should wipe off the front and rear panels and the cabinet with a soft cloth. For heavier dirt, dampen a soft cloth in a weak solution of mild detergent and water, wring it out dry, and wipe off the dirt. Following this, dry immediately with a clean cloth. Do not use rough material, thinners, alcohol or other chemical solvents or cloths since these may damage the finish or remove the panel lettering.
5.Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY.
•The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e.g., AC230V 50Hz or AC120V 60Hz) written on the rear panel.
•Models Equipped with a Voltage Selector Worldwide models are equipped with a voltage selector to conform to local power supplies. Be sure to set this switch to match the voltage of the power supply in your area before plugging in the unit.
Setting the voltage selector
SKW-205
VOLTAGE | |
SELECTOR | 120V |
VOLTAGE 220-230V
SELECTOR 120V
Setting the voltage selector
1.Determine the proper voltage for your area: 220-230V or 120V.
2.If the preset voltage is not proper for your area, insert a screwdriver into the groove in the switch. Slide the switch all the way to the lower (120V) or to the upper
3