Onkyo TX-SR875, TX-SR805 instruction manual Speaker Level Calibration

Advanced Setup—Continued

Speaker Level Calibration

These settings are set automatically by the Automatic Speaker Setup function (see page 55).

With the Level Calibration settings, you can adjust the level of each speaker while listening to the test tone so that the volume of each speaker is the same at the listen- ing position.

Note:

• The test tone is output at the standard level for THX,

which is 0 dB (absolute volume setting 82). If you nor-

mally listen at volume settings below this, be careful

because the test tone will be much louder.

3

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “4. Level Cali- bration,” and then press [ENTER].

The Level Calibration screen appears and the pink noise test tone is output by the front left speaker.

2-4.Level Calibration

Left	-12.0dB
Center	-12.0dB
Right	-12.0dB
Surr Right	-12.0dB
Surr Back R	-12.0dB
Surr Back L	-12.0dB
Surr Left	-12.0dB
Subwoofer	-15.0dB

1	Press the [RECEIVER] REMOTE
	MODE button, followed by the

RECEIVER [SETUP] button.

The main menu appears onscreen.

SETUP

Note:

•Levels cannot be adjusted for speak- ers set to No or None in the Speaker Configuration (page 86).

4		Use the Up and Down [	]/[	]
		buttons to select a speaker, and
		use the Left and Right [	]/[	]
	ENTER	buttons to adjust the level.
		Levels can be adjusted from –12 to
		+12 dB in 0.5 dB steps (–15 to +12 dB

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “2. Speaker Setup,” and then press [ENTER].

The Speaker Setup menu appears.

2.Speaker Setup

1.Speaker Settings 2.Speaker Config 3.Speaker Distance 4.Level Calibration 5.Equalizer Settings 6.THX Audio Setup

	for the subwoofer).
5	Repeat step 4 for each speaker
	so that the volume of the test
	tone from each speaker is the
	same.
	If you’re using a handheld sound level
	meter, adjust the level of each speaker
	so that it reads 75 dB SPL at the listen-
	ing position, measured with C-weight-
	ing and slow reading.
6	Press the [SETUP] button.
	Setup closes.
	S
	E
	T
	UP

Note:

•Speaker levels can also be adjusted by using the dedi- cated buttons on the remote controller. Press the [TEST TONE] button to output the test tone. Use the [CH SEL] button to select each speaker, and use the

[LEVEL–] and [LEVEL+] buttons to adjust the level.

90