2.3.2 CONNECT RS232 CRADLE
Start
Switch off the power of the host computer.
(ref. 1.) Choose proper place
Place the cradle in normal office conditions, avoid a place under strong light.
(ref. 2.) Set DIP switch
Set the required DIP switches for baud rate. For (default) settings notice DIP switch table in the next chapter.
(ref 3.) Connect interface cable
Connect the cable between the cradle and the host computer.
(ref. 4.) Connect power
Connect the power supply.
End
Switch on the power of the host computer. Place the bar code data collector in the cradle.
LED indicator
Typical LED indications are: red: power is on
flashing green: collector sends to host
flashing yellow: host sends to collector
FOR CONNECTING A NETWORK OF CRADLES SEE RS485 DESCRIPTION.
1
2
3
4
OPL972X/CRD972X OPTICON - 13