Appendices
Replacing the Lamp
The projection lamp should be replaced when it burns out. It should only be replaced with a certified replacement part, which you can order from your local dealer.
Important:
4The lamp contains a certain amount of mercury and should be disposed of according to local ordinance regulations.
4Avoid touching the glass surface of the new lamp, doing so may shorten its operation life.
Warning:
4Be sure to turn off and unplug the projector at least an hour before replacing the lamp. Failure to do so could result in a severe burn.
1 
2
B
A
B
34
1.Loosen the two captive screws on the lamp compartment cover
(A). Remove the lamp compartment cover (B).
2.Remove the two screws from the lamp module (A). Lift the module handle up (B).
3.Pull firmly on the module handle to remove the lamp module.
4.5 & 6. Insertion is the reverse of removal.
After replacing the lamp, the lamp hours counter must be reset. See page 43 for more information.
49 English
