Oracle Audio Technologies V adjust the plinth assembly, install the tone arm and phono cartridge

-Locate the bearing assembly in the lower section of the packaging. Remove the 3 mounting screws.

-Locate the tool kit in the lower section and select the appropriate allen key...

9/64th

-Lift the subchassis straight up and mount the bearing assembly from underneath (ground lug side). The bearing assembly can only be mounted in one position

Note: Important, the main bearing mounting flange is marked with a red dot. When installed this red dot must be on the axis of the motor pulley and the platter spindle. Any other positionning will impair the operation of your Delphi.

-Set the subchassis aside.

... adjust the plinth assembly

-Remove the styrofoam support blocks from around the suspension posts.

-Remove the suspension modules ( ie. the suspension housing, the spring and all related parts ) Remember that each module has or could have a different color coded spring. The modules have to go back on the same stem they came from.

-Remove the protective film from around the acrylic base.

-Level the plinth by turning the adjustable feet below.

Note:	If you do not have a small carpenter's level to do this job, use the styrofoam
	blocks as they were originally installed around the three suspension posts.
	Seat the subchassis evenly on the 3 blocks and use the spirit level on the
	subchassis to level the plinth.The suspension modules are not required for
	this operation.

... install the tone arm and phono cartridge

Note 1: The tonearm installation and calibration will be easier and safer with the sub-chassis resting on the foam shipping blocks as described earlier.

Note 2: The drive belt should not be used for this operation

Note 3: Do not pour the oil in the bearing well for this operation.

Note 4: Handle the platter installation carefully to prevent any damages to the bearing assembly.

-Install the platter without the drive belt.

-Place the tone arm mounting board loosely in the sub chassis mounting ring and determine the correct way to mount the arm to the arm board.

-Mount the tone arm to the pre-cut tone arm board.

-Install the tone arm following the manufacturer’s recommendations.

-Properly secure the tone arm mounting hardware.

... install the tone arm and phono cartridge ...

4