Oreck BB870-QD, BB870-EW, BB870-ED warranty Call Customer Service HOT Line

ORECK MANUFACTURING COMPANY: (Oreck 21180 Johnson Road; Long Beach, MS, USA 39560 gives you the following warranty for this product only if it was originally purchased for residential use, not resale from Oreck or an Oreck Authorized Retail Dealer.)

Oreck will repair or replace, free of charge, to the original purchaser, any part that is found to be defective in material or workmanship within three

(3)years of the date of purchase; ten (10) years on housing. This warranty applies to normal domestic use. Any commercial use of this product will void this warranty.

This warranty does not cover the replacement of expendable or consumable parts such as belts, brushes, bulbs, disposable bags and other parts subject to normal wear unless they are defective in material or workmanship.

This warranty does not apply to any part subjected to accident, abuse, alteration, misuse, damage caused by act of God, the use of voltages other than indicated on the serial number displayed on this product or service of this product by other than Oreck or a participating Factory Authorized Service Center.

Oreck does not authorize any person or representative to assume or grant any other warranty obligation with the sale of this product.

Oreck’s warranty is valid only if you retain proof of purchase from Oreck or an Oreck Authorized Retail Dealer for this product. If you purchase this product from any other source, your purchase is “AS IS,” which means Oreck grants you no warranty, and that you, not Oreck, assume the entire risk of the quality and performance of this product, including the entire cost of any necessary servicing or repairs of any defects.

This warranty is in addition to your statutory and other legal rights.

Reconditioned units carry a 6 month warranty from date of purchase.

WARNING: Unplug cord from electrical outlet before servicing.

•IMPORTANT: Make sure filter bag is in place. Do not operate cleaner without filter bag. Damage to motor may occur.

•Be sure bag gasket is in place. If the white bag gasket is damaged or lost, replace at once.

(Part No. 72017-02)

•For best results, change disposable filter bag regularly even if it is not completely full. An extremely dirty bag or a bag close to full will affect the suction of the cleaner and can create excessive motor heat that could damage the motor. A good practice is to change filter bag every 30 days even if it is not full.

•Do not pick up moist material or liquids.

•If fine materials such as soot, cement, plaster dust, copy machine powder, etc. are picked up, the bag surface may seal and suction will be reduced. Change bag when this occurs.

•Clean the disposable bag cavity and the outside of the canister with a damp (not wet) cloth.

•IMPORTANT: DO NOT REMOVE the dirt retaining flap attached on the back of the front plate. It must be left in place for the unit to operate properly and to ensure cleaning effectiveness.

ITEM		PART #
1.	Replacement Treated Filter Bags,
	12 pk. with 1 Micro Filter	PKBB12DW
2.	Replacement Micro Filter	72005-01
3.	Replacement White Bag Gasket	72017-02
4.	Oreck Fresh Air® Tabs	AIRTABS

WARNING: Unplug cord from electrical outlet before servicing

PROBLEM	POSSIBLE SOURCE	AREAS TO CHECK
CLEANER	Not plugged in	Be sure cleaner is
WILL NOT RUN	properly.	firmly plugged into
		wall outlet.
	No electricity in wall	Check electrical
	outlet.	source–fuse or
		circuit breaker.
	Needs Service.	Take to service
		center or call for
		nearest service
		center.
CLEANER	Filter bag is full.	Replace filter bag.
DOES NOT PICK UP		See “To Replace
OR HAS LOW		Paper Filter Bag.”
SUCTION	Hose / Wand tool is	Clear obstruction.
	clogged.
	Air leak due to	Replace Gasket
	missing or damaged
	gasket.

ALL OTHER SERVICING SHOULD BE DONE BY AN ORECK AUTHORIZED SERVICE CENTER.

CALL CUSTOMER SERVICE HOT LINE

0845 603 0153

Whenever calling, please be sure to have your model and serial number from data plate.

	1
10
4	3
8
2	9
	7
	5
	6

ITEM

1.Vacuum cleaner housing with paper filter bag and micro filter installed

2.Adjustable shoulder strap

3.Flexible hose with built-in adapter for easy insertion in vacuum or blower port

4.Crevice tool

5.Fabric tool

6.Bare floor and wall tool

7.Tool adapter tube for fitting tools directly to vacuum when not using hose

8.Two extension wands

9.Dusting brush

10.Tool Caddy

72080-07 REV B	©2005 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used
06/05 ECN# R-8022	under the authority of Oreck Holdings, LLC.