Oreck BR225 O perating I, T o S tore the C, T o R eplace F ilter B

Plug cord into electrical outlet.

Power Switch

Push power switch to

“ON” (l) position.

Operating Instructions

ELECTRIKBROOM

POWER SWITCH

Swivel Nozzle

The swivel nozzle feature

allows you to clean under

furniture easily. Simply twist

cleaner to side until the unit

lies flat and parallel to the

floor. Then guide the nozzle

into hard to reach places.

Cord Restraint

A cord restraint clip is

conveniently molded into the

handle to lift cord out of

your way while vacuuming.

CORD RESTRAINT

Telescopic Handle

To adjust the handle height,

simply grasp handle grip

and rotate collar lock at

lower end of handle

counter-clockwise to loosen.

Then slide handle up or

down to desired height.

Gently tighten collar lock

down clockwise onto threads

to lock handle into place.

COLLAR LOCK

ToStore the Cleaner

Wrap the power cord around rear of unit. For compact storage,

retract telescoping handle down. Hang cleaner on a hook from

the opening located at the top of the handle.

The convenient ORECK ELECTRIKBROOM vacuum cleaner is

always at your fingertips for quick clean-ups anywhere.

NOTE: These cleaners do not stand upright

alone. Make sure the cleaner is properly

supported when not in use or unattended.

ToReplace Filter Bag

To ensure that your ORECK ELECTRIKBROOM Powerbrush

cleaner provides you with optimal performance, use only ORECK

brand bags. Replace the filter bag more frequently when picking

up fine materials such as powders, plaster dust, ashes and soot.

These materials may seal the filter bag before it appears full.

STEP 1: Remove Filter Bag Assembly

Remove the filter bag assembly by:

1) Grasping its top and

pushing down.

2) Pulling top of filter bag

assembly out and away

from the cleaner.

STEP 2: Remove Used Filter Bag

Remove used filter bag by

grasping the cardboard

collar and pulling it past the

raised locking tabs on the

dirt tube. Discard used bag.

STEP 3: Install New Filter Bag

Install new filter bag by pushing cardboard collar past locking

tabs on the dirt tube. Make sure the filter bag is fully extended

and tucked into the filter bag assembly.

STEP 4: Replace Filter Bag Assembly

Replace bottom of the filter bag assembly into the side of the

cleaner. While pressing down, pivot top of filter bag assembly

in until to catch snaps into place.

To or der:

Replacement Filter Bags Part No. OR162

Call your authorized ORECK Service Center, your authorized

ORECK dealer, or the Service Center Hotline:

toll free at US: 1-800-989-3535

Canada: 1-800-393-8801