Oreck M800 Parts Checklist, Features, To Assemble Cleaner, Attach Nozzle, Operator Controls

Attach Wheels:

Attach Handle to Cleaner:

19	20		21	c
		c
		b	a	d
		a		b
22	23
		Slots
	a
Parts Checklist		Features

Read all instructions thoroughly before assembly/use. Please unpack carton, removing all parts and packages. Check that all parts required for assembly are present by referencing the list below.

PARTS		QUANTITY
1.	Oreck Steemer Unit	1
2.	Handle	1
3.	Oreck Steemer Power Nozzle	1
4.	Large, Easy-To-Steer Wheels	2
5.	Easy Lock-in Cleaner Cartridge/Bottle	1
6.	Screws (5/8”)	4
7.	Hand-held Nozzle and Hose Assembly	1
8.	Squeegee (for hard floor cleaning)	1

9.25’ Power Cord

10.A.L.C.I. – Safety Plug with Reset and Test Buttons

11.Translucent Upper Supply Tank

12.Translucent Lower Recovery Tank

13.Transparent Nozzle Cover

14.Motorized Scrubbing Brush

15.Convenient Quick-Release Cord Wrap

16.Floor Stand

17.Nozzle Power Cord

18.Support Legs

OPERATOR CONTROLS

19. Rinse/Shampoo Switch

20. Shampoo/Cleaner Spray Button

20

	23
	2
	1
	15
	19
	6
HOW TO USE	9
THE A.L.C.I

10

21

5

17

18

4

725

11

12

22

24

3

13

168

14

21.	A.L.C.I. Plug Reset Button
22.	Tank Latch
23.	On/Off Power Switch
24.	Nozzle Change Button
25.	Hand-held Nozzle Trigger

To Assemble Cleaner

A PHILLIPS SCREWDRIVER IS REQUIRED FOR ASSEMBLY! fig. 1

a.Lay the cleaner on a flat surface with the tank side down or to its side.

b.Slide handle into cleaner body until interlock is secured.

c.Insert four 5⁄8” screws (included) into the four cavities in the handle base and tighten.

fig. 2

a.Locate two wheels and two support legs.

b.Insert the wheels (a) into the support legs (b) by pushing the wheels in until they snap into place.

fig. 3 Attach Nozzle:

Turn the unit so that the tank is face up.

a. Align the nozzle so the nozzle change button is in line with the

corresponding hole in the nozzle. Depress the small nozzle

change button and slide the nozzle over the unit shaft until the

button locks into place.

NOTE: Before using, please read the important safety and operating instructions.

4

fig. 4 Plug the small power nozzle cord connected to the nozzle into the receptacle in the back of the unit.