E N G L I S H
Assembly.
Assembly Instructions
1Attach wall mount to a flat surface using the screws provided.
2Insert the round end of the brushroll against the
3Attach handle to the end of strut with the telescopic wand adjustment. Pressing down the locking tab, slide shorter strut over longer strut until locking tab catches. Insert assembled handle into base until it locks in place.
Loosen the telescopic wand adjustment to lengthen or shorten the handle to the desired length and then tighten telescopic wand adjustment.
4Insert battery into battery compartment until it “snaps” in place. Connect the power adapter and allow the unit to charge for 14 hours.
The LED charging display will light when charging. If the LED does not light when charging, check to make sure the unit is in the OFF position. NOTE: The unit will not charge if left in the ON position.
It is recommended that you remove the power adapter from the unit once the unit has completely charged.
1 | 2 |
3 | 4 |
4
