Oreck TEK 100 important safety instructions Safety Warning

Models: TEK 100

1 12
Download 12 pages 57.57 Kb
Page 3
Image 3
Safety Warning

Safety Warning

1.Be sure to use the product in compliance with the contents of this manual, and use approved Oreck replacement parts.

2.After unpacking, make sure that the appliance is intact with no visible signs of damage caused during shipping. If damage has occurred, do not use this product. Take it to an authorized Oreck Clean Home Center for service. All packing materials (plastic wrapping, cardboard box, etc) are potentially dangerous and must be kept out of children’s reach.

3.Do not leave this product unattended when power is on.

4.Be sure to keep the air intake free and clear of any large debris which can cause a blockage in the air flow, impacting overall performance.

5.Be sure to keep the air exhaust outlet free and clear to prevent the risk of the motor burning out.

6.Do not use this product on uneven floors or surfaces and be careful when cleaning stairs to prevent this unit from falling down.

7.Keep away from heat sources (such as central heating air vents, ovens, etc.) to prevent the distortion of plastic parts.

8.Before using this product, please remove any large or sharp matters on the floor in order to avoid damaging internal parts including the filter and motor.

9.Do not try to pick up wet or other liquid items, which will result in damage to the motor.

10.Keep any loose clothing items away from moving brush roll.

11.The charger is uniquely designed for the rechargeable Ni-MH battery, rating: Input: 120V, 60 Hz, 50mA

Output: 9V DC, 280Ma

Class: 2

12.After inserting the plug of the charger into the electrical socket, the power light (green) will illuminate. Insert the rechargeable battery module, this will cause the charge indicator light (red) to blink. Battery will be fully charged after 8 hours when red light is solid (not blinking).

13.Once the battery is fully charged, it can be placed into the unit. Before doing so, be sure to switch the power “OFF” to prevent any possible electrical charge.

14.The brush roll should be cleaned on a regular basis in order to maintain optimal performance.

15.The filter inside the dirt cup can simply be washed in warm soapy water and can be used again after drying.

16.It’s suggested to change the filter every 6-12 months, however this may vary depending upon use.

2

Page 3
Image 3
Oreck TEK 100 important safety instructions Safety Warning