E N G L I S H
Maintenance.
Replacing Disposable Filter Dust Bag
WARNING: Unplug cord from electrical outlet before servicing.
BAG REMOVAL:
5Unzip outer bag completely.
6Pull bag cardboard collar to release bag dock door from connector. Bag dock door will hinge downward.
7Gently pull bag cardboard collar upward out of the bag dock. Saniseal® dust seal will close automatically.
BAG INSTALLATION:
8Slide the cardboard collar completely onto bag dock door.
9Firmly push bag dock door with both thumbs on indication point until it snaps.
ENFONCEZ JUSQU’À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
5 | 6 | 7 | 8 | 9 |
Replacing Worn Belt
WARNING: Unplug cord from electrical outlet before servicing.
10Remove the replacement belt from the storage channel.
11Remove the door by removing the hold down screw located on side of power head.
12Fold door away from the power head and lift it away.
13Remove the belt from the motor drive shaft and brush roll pulley.
14Loop the new belt over the brush roll pulley. Place the opposite end of the belt on the motor drive shaft.
12Replace the door by placing the bottom tab on door into slots located inside power head and pressing the door closed.
11Replace the hold down screw and tighten.
10 | 11 |
12
13
14
Adjusting or Replacing Brushroll
WARNING: Unplug cord from electrical outlet before servicing.
To determine if the brushroll is worn, place a firm straight edge across the nozzle opening. If brushroll bristles do not extend beyond baseplate, brushroll should be adjusted.
15Remove the baseplate by removing 5 screws. Then, remove the belt and brushroll from the housing.
16Rotate both bearing assemblies at ends or brushroll to show “OLD” and replace in the holding channels in the housing.
17Note: The bearing assembly setting marked “OLD” has no ribs on the top of the assembly.
18The one marked “NEW” has several ribs. When rotating bearings, make sure both bearing assembly settings are the same and face up when replacing the brushroll.
14Reassemble the belt.
15Reassemble the baseplate.
6
