Oreck Upright Bag Vacuum Cleaner warranty Parts List, General Information, Assembly

Parts List

To assist you in identifying components of your vacuum, the parts have been numbered as follows:

1	Handle section, upper	8	Bag tension bar
2	Tube, lower	9	Zip fastener
3	Power head	10	On/off switch
4	Outer bag	11	Cord hook
5	Paper filter dust bag	12	Plastic loop/cable clamp
6	Power cord	13	Connector assembly
7	Retaining spring	14	Fan housing
		15	Cord assembly

NOTE: Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time. Keep the unit moving while in operation.

For Easy Power Cord Storage

fig. 5 Wrap power cord around cord hook on handle and cord hook on connector. Secure to "U" shaped part on plug.

Operating Recommendations

This new ORECK XL High-Speed Upright is one of the finest, fastest, and strongest units in its class. You’ll love the way it cleans, gets under things, and it’s SO lightweight and easy to use.

The following are a few simple suggestions regarding its operation:

1.When inserting a new disposable paper filter dust bag—FIRST PUFF OUT and OPEN THE BAG.

	Straight Handle				Helping Hand®		Handle			2.	When the disposable filter dust bag is full, REPLACE IT.
						10				3.	If at any time the machine does not pick up properly or makes an
											unusual noise, STOP OPERATION and service.
								11
	9				9	1				4.	Although your upright will pick up pins, paper clips, and other small
				11			12				objects, it is recommended that these be removed from the floor
5		1									before you vacuum. Failure to do so may result in permanent
											damage to the motor suction fan and its housing.
										5.	WARNING: Do not use your vacuum cleaner on damp or wet
					5		13				surfaces. This will cause damage to the vacuum cleaner and is
	4	12									dangerous to the user. Damage caused by use on wet or damp
			2		4						surfaces is not covered under warranty.
				6			2		6	6.	REPLACE THE BELT EVERY 6 MONTHS.
										7.	Change the disposable filter dust bag at least once a month—even
			10
		7		14							if it is not full! The collected dust in the dust bag can cause odor,
											attract moisture, and can affect the efficiency of the cleaner.
								15
	8				8	7	14			8.	DO NOT run the vacuum cleaner over the cord. The revolving
											brush could damage the cord.
	3
										9.	Use caution when vacuuming over area rug edges and fringe.
Power Head
					3					General Information
with Foot Switch						Power Head

with Square Lens

Power Head

with Curved LensThe performance of your new cleaner greatly depends upon care and maintenance. The instructions in this manual will guide you in performing

Assembly

basic care and maintenance. To obtain the most satisfying years of

service read the instructions and keep them handy for future reference.

Disposable Paper Filter Dust Bags

fig. 1 Before assembling appliance, remove two screws from connector assembly. Remove cardboard insert by pulling upward.

fig. 2 Slide upper handle section over matching section of the connector assembly. Insert screws in holes and tighten firmly until handle is no longer loose.

fig. 3 Attach cord to cord clip by pressing above and below clip ensuring the cord is fully rested in clip. (Note: Some units come with an enclosed cord clip that is already assembled.)

Operating Instructions

Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet.

Note: Read the unit descriptions below and follow the directions that apply to your unit.

Switch On Base: Press the ON (l) - OFF (O) switch on top of base when ready to operate.

Single-Speed Helping Hand® Handle: Press the ON(l) - OFF(O) switch on handle assembly when ready to operate.

Two-Speed Helping Hand® Handle: Press the On-High (ll) - On-Low (l)

-OFF(O) switch on handle assembly when ready to operate.

Up-Position Lock

fig. 4 Place foot on power head and lean handle back gently to release lock for vacuum use. Return handle to the full upright position to engage lock.

Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the paper bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the paper bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner’s power.

To keep your cleaner operating at maximum efficiency, change the dust bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE

DUST BAG.

Be sure the disposable paper filter dust bag is installed properly.

All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner. Using bags other than genuine ORECK Type CC disposable bags will affect the cleaning ability of your cleaner and could cause damage to it.

The Belt

The belt on your vacuum cleaner controls the speed of the revolving brush and is very important for the effective operation of the cleaner. If the belt becomes stretched or cut, it will cause the revolving brush to stop completely or slow down. See instructions in the manual for replacing belt.

An extra belt is stored in the baseplate of your cleaner. When buying replacement belts, use ONLY ORECK genuine belts. Belts other than Oreck belts will not operate the revolving brush correctly and may create undue stress which will cause damage to the motor and brush bearings. Using belts other than ORECK belts will void the warranty.

5