Parts List

To assist you in identifying components of your vacuum, the parts have

been numbered as follows:

10

 

 

 

 

11

1

Handle section, upper

9

2

Tube, lower

1

3

Power head

4Outer bag

5Paper filter dust bag

6Power cord

7Retaining spring

8

Bag tension bar

5

4

13

 

9

Zip fastener

 

 

12

6

10

On/off switch

 

 

2

 

11

Cord hook

 

 

 

12

Plastic loop/cable clamp

 

 

 

13

Connector assembly

 

 

7

15

14

Fan housing

 

 

14

 

 

 

15

Cord assembly

 

 

 

 

 

 

 

8

5.WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the vacuum cleaner and is dangerous to the user. Damage caused by use on wet or damp surfaces is not covered under warranty.

6.REPLACE THE BELT EVERY 6 MONTHS.

7.Change the disposable filter dust bag at least once a month— even if it is not full! The collected dust in the dust bag can cause odor, attract moisture, and can affect the efficiency of the cleaner.

8.DO NOT run the vacuum cleaner over the cord. The revolving brush could damage the cord.

9.Use caution when vacuuming over area rug edges and fringe.

General Information

The performance of your new cleaner greatly depends upon care and maintenance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying years of service read the instructions and keep them handy for future reference.

Disposable Paper Filter Dust Bags

Assembly

3

Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the paper bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the paper bag becomes clogged, no air can

fig. 1 Before assembling appliance. Remove two screws from connector assembly. Slide upper handle section over matching section of the connector assembly. Insert screws in holes and tighten firmly until handle is no longer loose. Insert plug on cord assembly into handle. Machine should be in upright position when inserting cord assembly into handle.

Operating Instructions

Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet and press the On(l) - OFF(O) switch on handle assembly when ready to operate.

Safety-Lighted Power Switch

fig. 2 When the unit is plugged in the electrical outlet and power is present, the On/Off power switch will illuminate RED. This is to idicate power is present and to prevent the unit from being left powered while not in use. Do not leave appliance unattended when plugged in.

Up-Position Lock

fig. 3 Place foot on power head and lean handle back gently to release lock for vacuum use. Return handle to the full upright position to engage lock.

NOTE: Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time. Keep the unit moving while in operation.

For Easy Power Cord Storage

fig. 4 Wrap power cord around cord hook on handle and cord hook on connector. Secure to "U" shaped part on plug.

Operating Recommendations

This new ORECK XL High-Speed Upright is one of the finest, fastest, and strongest units in its class. You’ll love the way it cleans, gets under things, and it’s SO lightweight and easy to use.

The following are a few simple suggestions regarding its operation:

1.When inserting a new disposable paper filter dust bag—FIRST PUFF OUT and OPEN THE BAG.

2.When the disposable filter dust bag is full, REPLACE IT.

3.If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and service.

4.Although your upright will pick up pins, paper clips, and other small

objects, it is recommended that these be removed from the floor

 

before you vacuum. Failure to do so may result in permanent

5

damage to the motor suction fan and its housing.

pass through the cleaner and cleaning cannot take place, regardless of the cleaner’s power. To keep your cleaner operating at maximum efficiency, change the dust bag frequently.

DO NOT FILL ABOVE THE LINE INDICATED ON THE DUST BAG.

Be sure the disposable paper filter dust bag is installed properly.

All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner and using bags other than genuine ORECK TYPE CC disposable bags will affect the cleaning ability of your cleaner and could cause damage to it.

The Belt

The belt on your vacuum cleaner controls the speed of the revolving brush and is very important for the effective operation of the cleaner. If the belt becomes stretched or cut, it will cause the revolving brush to stop completely or slow down. See instructions in the manual for replacing belt.

An extra belt is stored in the base-plate of your cleaner. When buying replacement belts, use ONLY ORECK genuine belts. Belts other than Oreck belts will not operate the revolving brush correctly and may create undue stress which will cause damage to the motor and brush bearings. Using belts other than ORECK belts will void the warranty.

Lubrication

The vacuum cleaner motor bearings are factory lubricated and sealed. Further lubrication is not required.

General Cleaner Care

At least once a month, check for and remove excessive lint, string or hair from revolving brush.

Wipe the outside of the cleaner with a damp cloth. Also clean the connector deflector assembly area, base of cleaner and fan housing area. If there is dust in the outer bag, vacuum it or shake it out.

A little preventative maintenance will keep your cleaner looking new and will ensure continued cleaning effectiveness.

Page 4 Page 6
Page 5
Image 5
Oreck XL3600RH warranty Parts List, General Information, Assembly, Operating Instructions
Page 4 Page 6

XL3600RH specifications

The Oreck XL3600RH is a powerful and lightweight upright vacuum cleaner designed to tackle various cleaning tasks in both home and commercial environments. Weighing just 8 pounds, the Oreck XL3600RH is easy to maneuver, making it an ideal choice for users who want a vacuum that is both efficient and convenient.

One of the standout features of the Oreck XL3600RH is its proprietary Saniseal technology. This innovative feature ensures that dirt and debris are contained within the vacuum bag. When you dispose of the bag, the Saniseal technology automatically seals it shut, preventing dust and allergens from escaping back into the air. This is particularly beneficial for individuals with allergies or respiratory sensitivities, as it helps maintain a cleaner and healthier indoor environment.

The Oreck XL3600RH is equipped with a high-speed, multi-cyclonic filtration system that effectively captures dirt and allergens while also maintaining strong suction power. The vacuum utilizes a unique roller brush system that operates at an impressive speed of 6,500 RPM. This high-speed agitation helps dislodge and capture dirt embedded in various types of carpets and rugs, allowing for thorough cleaning.

Another notable characteristic of the Oreck XL3600RH is its low-profile design. The vacuum is engineered to easily glide underneath furniture and other hard-to-reach spaces, ensuring that no area is left uncleaned. Its slim and compact design also makes it easy to store, taking up minimal space in closets or utility rooms.

For added convenience, the Oreck XL3600RH features a 40-foot power cord, providing an extended reach that reduces the need for frequent outlet changes during cleaning sessions. This capability is especially advantageous for larger spaces, such as open living areas or commercial facilities.

Moreover, the Oreck XL3600RH comes with a variety of onboard tools, including a dusting brush, crevice tool, and upholstery tool. These accessories allow users to tackle different surfaces, from delicate curtains to tight corners, ensuring comprehensive cleaning throughout the home or office.

In summary, the Oreck XL3600RH is a lightweight, powerful vacuum cleaner that combines advanced technologies like Saniseal and multi-cyclonic filtration to provide an exceptional cleaning experience. With its low-profile design and extensive reach, it is an ideal choice for anyone seeking an effective and user-friendly cleaning solution.
Top Page Image Contents