Parts List, Assembly, Operating Instructions

E N G L I S H

Parts List

To assist you in identifying components of your vacuum, the parts have been numbered as follows:

				10
1	Handle section, upper			9	1	11
2	Tube, lower			9	1
2	Tube, lower
3	Power head				12
4	Outer bag
5	Paper filter dust bag
6	Power cord
7	Retaining spring	5			13
8	Bag tension bar	5	4		13
8	Bag tension bar		4
9	Zip fastener
10	On/off switch				2
11	Cord clamp				2	6
11	Cord clamp					6
12	Plastic loop/cable clamp
13	Connector assembly
14	Fan housing		8	7	14
15	Cord assembly				14	15
15	Cord assembly					15

Assembly

fig. 1 Before assembling appliance, remove two screws from the connector assembly. Remove cardboard insert by pulling upward.

fig. 2 With ON/OFF switch facing the front of the unit, slide upper handle section over matching section of the connector assembly. Insert short screw into top hole and long screw into the bottom hole then tighten firmly until handle is no longer loose.

fig. 3 Attach cord to cord clip by pressing cord above and below clip ensuring the cord is fully rested in clip.

Operating Instructions

Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet and press the On Low (l) - On High (ll) - OFF(O) switch on handle assembly when ready to operate.

Up-Position Lock

fig. 4 Place foot on power head and lean handle back gently to release lock for vacuum use. Return handle to the full upright position to engage lock.

NOTE: Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time. Keep the unit moving while in operation.

For Easy Power Cord Storage

fig. 5 Wrap power cord around cord hook on handle and cord hook on connector. Secure to "U" shaped part on plug.

Operating Recommendations

This new ORECK XL High-Speed Upright is one of the finest, fastest, and strongest units in its class. You’ll love the way it cleans, gets under things, and it’s SO lightweight and easy to use.

The following are a few simple suggestions regarding its operation:

1.When inserting a new disposable paper filter dust bag—FIRST PUFF OUT and OPEN THE BAG.

2.When the disposable filter dust bag is full, REPLACE IT.

3.If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and service.

4.Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these be removed from the floor before you vacuum. Failure to do so may result in permanent damage to the motor suction fan and its housing.

5.WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the vacuum cleaner and is dangerous to the user. Damage caused by use on wet or damp surfaces is not covered under warranty.

6.REPLACE THE BELT EVERY 6 MONTHS.

7.Change the disposable filter dust bag at least once a month— even if it is not full! The collected dust in the dust bag can cause odor, attract moisture, and can affect the efficiency of the cleaner.

8.DO NOT run the vacuum cleaner over the cord. The revolving brush could damage the cord.

9.Use caution when vacuuming over area rug edges & fringe.

General Information

The performance of your new cleaner greatly depends upon care and maintenance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying years of service read the instructions and keep them handy for future reference.

Disposable Paper Filter Dust Bags

Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the filter bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the filter bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner’s power.

To keep your cleaner operating at maximum efficiency, change the dust bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE

DUST BAG.

Be sure the disposable paper filter dust bag is installed properly.

All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner. Using bags other than genuine ORECK TYPE CC disposable bags will affect the cleaning ability of your cleaner and could cause damage to it.

The Belt

The belt on your vacuum cleaner controls the speed of the revolving brush and is very important for the effective operation of the cleaner. If the belt becomes stretched or cut, it will cause the revolving brush to stop completely or slow down. See instructions in the manual for replacing belt.

An extra belt is stored in the baseplate of your cleaner. When buying replacement belts, use ONLY ORECK genuine belts. Belts other than Oreck belts will not operate the revolving brush correctly and may create undue stress which will cause damage to the motor and brush bearings. Using belts other than ORECK belts will void the warranty.

Lubrication

The vacuum cleaner motor bearings are factory lubricated and sealed. Further lubrication is not required.

General Cleaner Care

At least once a month, check for and remove excessive lint, string or hair from revolving brush.

Wipe the outside of the cleaner with a damp cloth. Also clean the connector deflector assembly area, base of cleaner and fan housing area. If there is dust in the outer bag, vacuum it or shake it out.

A little preventative maintenance will keep your cleaner looking new

XL3900H2, XL3910H2 specifications

The Oreck XL3910H2 and XL3900H2 are two powerful vacuum cleaners designed to provide exceptional cleaning capabilities for both residential and commercial spaces. Oreck has built a reputation for creating lightweight yet powerful cleaning solutions, and these models are no exception.

One of the standout features of the Oreck XL3910H2 and XL3900H2 is their unique design, which makes them extremely lightweight. Weighing in at around 8 pounds, these vacuum cleaners are easy to maneuver, allowing users to carry and push them without straining. This is particularly beneficial for those who need to clean large areas or navigate stairs.

Both models are equipped with a high-speed roller brush that effectively captures debris and dirt from various surfaces. This brush spins at an impressive rate, ensuring that even embedded dirt is lifted from carpets and rugs. The Oreck XL series is designed to be equally effective on both carpets and hard floors, making it versatile for different cleaning needs.

Another notable characteristic is the top-fill dust bag system. This design ensures that the vacuum maintains strong suction power even as the bag fills up. The Oreck XL3910H2 features a larger dust bag compared to the XL3900H2, which means users can clean longer without needing to replace the bag. This is not only convenient but also economical, as it reduces the frequency of maintenance.

In terms of filtration, both models utilize a hypoallergenic inner bag, which captures allergens and fine dust particles. This is particularly advantageous for allergy sufferers, as it helps to maintain a cleaner and healthier indoor environment. Additionally, the vacuum’s sealed design minimizes dirt leakage, enhancing the overall efficiency of the cleaning process.

The Oreck XL3910H2 and XL3900H2 also incorporate a convenient cord management feature. With a generous 40-foot cord length, users can clean large areas without needing to constantly switch outlets. This design saves time and enhances productivity, making these vacuums ideal for both home cleaning and professional use.

In summary, the Oreck XL3910H2 and XL3900H2 combine lightweight construction with powerful cleaning performance, making them suitable choices for various cleaning tasks. With their effective brush systems, top-fill bags, allergen filtration, and user-friendly features, these vacuums are engineered to deliver top-notch performance for maintaining a clean and healthy living environment.

Oreck XL3900H2, XL3910H2 warranty Parts List, Assembly, Operating Instructions, General Information

Models: XL3900H2 XL3910H2