EN
Backup power
1 piece AAA battery
In the case when the rechargeable battery is flat or nearly flat or when the solar panel has been detached, the AAA battery can act as backup power supply for the main unit.
1.Remove the battery compartment located at the base of the unit.
2.Insert the battery, matching the polarity.
3.Press RESET after each battery change.
Power adaptor (not included)
The adaptor powers the unit and can also be used for charging the rechargeable battery. When connected to the
main unit, | will be displayed. |
NOTE The main unit and adaptor should not be exposed to wet conditions. No objects filled with liquid, such as vases, should be placed on the main unit and adaptor.
Remote sensor
This product can work with up to 3 sensors at any one time to capture temperature readings in various locations.
To set up the remote sensor:
1.Slide open the battery compartment.
2.Slide channel switch to select a channel (1, 2, 3).
Ensure you use a different channel for each sensor.
3.Insert the battery, matching the polarities.
4.Press RESET after each battery change.
5.Close the battery compartment.
6.Press and hold SEARCH for 2 seconds to initiate a sensor search.
NOTE Use alkaline batteries for longer usage and consumer grade lithium batteries in temperatures below freezing.
The remote sensor reception icon will show the following status:
ICONS | MEANING |
Main unit is searching for sensor(s)
A sensor channel has been found
No sensor found
TIP Ideal placements for the sensor would be in any location on the exterior of the home at a height of not more than 1.5 m (5 ft) and which can shield it from direct sunlight or wet conditions for an accurate reading.
