Outdoor measurements are collected by the remote unit.
Temperature is give at the top; humidity is below.
VIEW MIN / MAX / CURRENT MEASUREMENTS Press SELECT 3 times until the Temperature and Humidity Areas flash. Press UP or DOWN to scan the readings.
CLEAR MIN / MAX MEASUREMENTS
While viewing Min/Max measurements, press and hold UP or DOWN for 2 seconds until a beep sounds. This clears the previous measurements from the memory.
EN
SELECT REMOTE UNIT CHANNEL
While in the Temperature / Humidity Mode, press CHANNEL to switch between CH 1, 2, or 3, or press and hold CHANNEL for 2 seconds to enter Auto scan mode. If only 1 remote unit is in use, you will not be able to change channels or Auto scan. If you select “Auto”, the channel will change every 3 seconds. To deactivate, press and hold CHANNEL for 2 seconds again.
SENSOR SEARCHING
If there is no remote unit signal, the temperature and humidity measurements will be blank. Check the remote unit batteries, or press and hold UP and DOWN for 2 seconds to search for the remote unit(s).
15
| 17 | 8/8/03, 11:35 AM |
