6
REMOTE CONTROL
Open the battery compart-
ment cover in the direction
of the arrow.
Install two “AAA” batteries
(supplied), paying attention
to the polarity diagram in
the battery compartment.
Replace the compartment
cover.

INSERTING BATTERY

OPERATION

While pressing on both
sides of the clip, remove it
from the unit while pulling
with an upward motion.
Gather up the cables
between the holes of the
cable holder.

TO BUNDLE THE CONNECTED CABLE

•Aim the remote control at the remote sensor and
press control buttons to operate.
•Operate the remote control within 30° angle on
either side of the remote sensor, up to a dis-
tance of Approx. 5 meters.
Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.
The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote
sensor may shorten the operating distance.
Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries
properly.
Do not mix old and new batteries.
Remove batteries if the remote control will not be operated for an extended period of time.
Approx. 5 metres
NOTES:
•
•
•
•
•
(CONTINUED)
Replace the cable holder.