Orion HP-RB1 warranty Front Panel, Rear Panel

G41710_01-06.qxd 1/16/06 2:44 PM Page 2

FRONT PANEL

(1) ILLUMINATED RING

(2)REMOTE BASS CONTROL

MIN MAX

The front panel of the HP-RB1 consists of:

1.LED illuminated outer ring - which will glow (when the power connections are made).

2.Remote Bass Control - Rotate clockwise to increase the amount of bass/gain, or counterclockwise to reduce the bass/gain. This control can be recessed by pushing on the control.

REAR PANEL

GND +12V

(2) 3.5mm “MINI”

(1) TWO-WIRE PHONE JACK LED HARNESS

LED

The rear panel has 2 connections:

1.A two-wire harness allows control of the illumination of the LED. Connect the Red + wire to a illumination control output, or to a source of 12-15V power (current draw is less than 20mA). Connect the Black or GND lead to a convenient power ground. The control and illumination circuits are independent.

2.A standard 3.5mm "mini" phone jack connects the gain control knob to the cor- responding amplifier via a 2 conductor, 15 foot cable. Connect the other connec- tor to the remote jack on the amplifier.

Attach the body of the unit to the underside of the dash using 2 screws on either side of the control housing.

Note: The control can be removed from the housing if flush-mounting is desired. Remove the two hex head screws at the side. Remove the 2 Phillip’s head screws securing the PCB. Remove the ring retainer on the front of the control, and then remove the PCB.

Note: Before drilling any holes verify that there are no obstructions (wiring, ven- tilation, etc) on the other side of the dash.

2 © 2006 Directed Electronics—all rights reserved