2©2003 Directed Electronics, Inc.
In-Dash Mounting
Note: There must be enough clearance behind the dash-panel before
selecting the location to mount the RGC-1.
A 1/2-inch hole must be drilled to mount the RGC-1 in the dash panel. Side in the control
from the rear of the dash panel and place the trim label on the threaded shaft. Secure the
control with the nut and mount the knob
If there is no access to the back of the dash panel, drill a 3/4-inch hole in order to pass the
entire RGC-1 through the hole from the front of the dash panel. Once the control is through
the hole, the clip shown below is passed through the hole and slid around the threaded
shaft of the control. Place the trim label on the threaded shaft and secure the control with
the nut and mount the knob.
Front Mount
Rear Mount
AC502
AC502
Nut
Nut
Clip Dashboard
Trim Panel
Label
NutKnob
DashboardLabel Nut Knob
Under Dash
Mounting
AC502
Nut Bracket
Label
Screws
Nut
Knob