Rear Seat | Rear/Trunk |
| of Car |
Figure 2
Figura 2
Abbildung 2
STEP BY STEP INSTALLATION
Step 1: Determine where the speaker will be mounted. Make sure there is a flat area large enough for the speaker to fit properly. An uneven mounting surface can damage the driver.
Step 2: Check to make sure the space you have chosen for the speaker will not interfere with the operation of the vehicle.
Step 3: Using a template, mark the speaker hole with a pen.
Step 4: Cut the hole for the speaker. When using factory locations, this step can be passed. A hole can be cut either with a pair of metal tin snips or a hole saw corresponding to the size of the speaker listed below.
•41/8" (105mm) hole saw (4"Coaxial installation)
•43/4" (120mm) hole saw (5.25"Coaxial installation)
•51/8" (130mm) hole saw (6" & 6.5" Coaxial installation)
Step 5: Run the speaker wire to the speakers. Make sure to keep wires away from sharp metal or other edges. When passing through metal ,use a protective grommet.
Step 6: Using the template, mark the mounting holes with a pen.
Step 7:
Step 8: Pull the wire through the speaker opening and connect to the speaker.
Step 9: Mount the speaker and grill in the hole using the same screws. Insert the screws through the grill and the mounting holes in the basket.
WARNING: Window mechanisms and electrical wires may be hidden from sight.
CHECK FOR CLEARING BEFORE YOU DRILL!
4 | © 2008 directed |
