USING YOUR BLENDER
1.Clean blender according to the instructions in the “Cleaning and Storing Your Blender” section.
2.Turn jar upside down so the small opening is at the top. (Figure 1)
3.Place sealing ring over jar opening. (Figure 2)
4.Place blade into jar. (Figure 3)
FIGURE 1 | FIGURE 2 |
5.Place threaded jar nut over blade and jar. Place the threaded jar nut on jar and turn it clockwise to tighten. (Figure 4)
6.Place jar assembly onto base. (Figure 5)
7.Make sure jar is seated into position.
8.Place ingredients into jar.
9.Place lid with filler cap on jar.
10.Plug the power cord into a 120 Volt AC electrical outlet.
11.Slide switch to HIGH or LOW.
12.Push desired speed and blend ingredients to desired consistency.
13.Press OFF to stop the blender.
14.To use PULSE, select HIGH or LOW. Push PULSE and hold down for desired length of time. Release PULSE and allow blade to stop. Repeat cycle as desired.
FIGURE 3
FIGURE 4
FIGURE 5
4
