Outback Power Systems 500 T

• Never use less than the minimum recommended number and type of fasteners when installing

the FLEXware Mounting Plates.

• Each FX weighs in excess of 50 lbs and is often more easily installed by two people rather

than one.

• Be sure the DC enclosure is secured to the FLEXware Mounting Plate before attaching the

MX Charge Controller to it.

• Installation of each enclosure and breakers is normally easier by removing the breaker brackets

rst. Do not remove any breaker knockouts from these brackets without referring to the chosen

AC IOB kits and DC breaker selections rst.

• It is also easier if all conduit knock outs are removed before mounting the enclosures.

FLEXware 500 is designed for mounting on the FLEXware Mounting Plate (FW-MP). Although the

components can be secured to other surfaces, the FW-MP is an engineered platform designed

for the FLEXware 500 installation. This manual illustrates such an installation. OutBack does not

endorse other installation methods and therefore cannot recommend fasteners or other means of

attachment due to the variety of installations possible in the eld.

Please see the FLEXware Mounting Plate Instructions for further information.

In addition to installing the AC and DC chassis, a typical installation includes two FX Series

Inverter/Chargers, an MX60 Charge Controller, a HUB Communications Manager, and AC and DC

conduit adapters. The installation of these components is also displayed in these instructions.

T Slot indicates this is the top edge of the FW-MP

Figure 3: FLEXware Mounting Plate