A complete FLEXware 500 System consists of the following in addition to the FW500-AC
and FW500-DC:
• FLEXware Mounting Plate (FW-MP)
• two FX Series Inverter/Chargers
• AC Conduit Adapter (ACA) and a DC Conduit Adapter (DCA), which connect each FX to the
FW500-AC and FW500-DC
• MX Charge Controller(s) (normally part of this system) and mounting brackets
• AC and DC breakers including a specic AC Input/Output/Bypass Breaker (IOB) Kit
per installation
• bus bars and DC current shunts as required per specic installation
• DC and AC ground fault protection
Some systems will work optimally with an FW-X240 Auto-Transformer installed.
Note: Be sure you have all the parts required for your intended system installation. As every
installation is dierent, consult with your dealer or installer for further information.
FLEXware 500 Parts List
FLEXware 500 consists of the FW500-AC and FW500-DC. Each is an aluminum chassis for mounting
AC and DC breakers, respectively, along with the components listed below:
FW500-AC components:
• aluminum enclosure
• DIN rail bracket
• Breaker and Bypass Mounting Bracket
• TBB-GROUND
• ex nylon conduit and ttings
(conduit runs between the FW500-AC
and FW500-DC as needed)
FW500-DC components:
• aluminum enclosure
• 500 amp shunt with TBB attached
• TBB-GROUND
• FW breaker bus
• DC Breaker Mounting Bracket
• FW500-DC Hardware Kit
• DC positive bus bar
• jumper wire from DC negative to ground
4