and will damage the Media Center if this is done. Please note that the power supply must be plugged in to a
5)Finish terminating all the wiring before powering up the MEDIA CENTER.
6)Turn on amplifier and test system.
7)Next place the amplifier into the gang box and add the screws to the face screws and add the screws to the faceplate and test the system one last time.
Connecting the Media Centers to another Media Center
Note: If you are going to do this please note that you will lose one of the inputs on all of the
additional MEDIA CENTERS.*
1)Connect a line between the Media Center to the other MEDIA CENTERS with either a 2 conductor wire or
2)Connect the other local equipment in the room (microphone/s or Sources) to the MEDIA CENTER to the other desired input (1, 2, or 3) be sure that the jumper (red plastic) is in the correct Mic or line spot.
3)Connect the speaker wires to the SPKR CH1 phoenix connectors SPKR CH 2.
*Everything from the first MEDIA CENTER will be heard on all the speakers if the slide switch is greater than the off position.
System is now fully operational.
Description:
Specifications:
•2 x 25 Watt Amplifier
•15 Volt DC Power
•Three Selectable, Balanced Mic/Line Inputs
Features:
•Latest Digital Amp Design
•Three Selectable, Balanced Mic/Line Inputs
•Onboard Limiting
•Active Balanced Line Output
•Individual Mic/Line Controls
•Uses Latest Surface Mount Technology
•Short Circuit Protected
•Over Voltage Protected
•Over Heat Protected
•UL Rated Power Supply
•
•Dockable Wire Connectors
•Master Gain Control
•Projector Compatible
•Allows for Input Wire Runs of up to 3000 feet
•Allows for Line Out Wire Runs of up to 3000 feet
•Double Gang Box Shallow Mounting
•Finger Tip Sliders (Reduces chance of breakage)
•Up to 8 Speakers Maximum (4 speakers per side)
•Best use with OWI Model ICT82A
•Warranty – 1 year
Page 5 of 6 | Filename:MEDIA CENTER MANUAL |
| 12/11/06 |
