Palsonic 3498 Operating Instructions, Antenna Connections, Power Switch, Channel Selection

INSTALLING BATTERIES:

1.Remove the battery cover of Remote Control Unit.

2.Insert two "AA" 1.5V batteries making sure the polarity (+ or -) of the batteries matches the polarity marks inside the unit.

3.Close the battery cover.

*When the Remote Control Unit is not used for a long time or the batteries are worn out, take out the batteries to prevent electrolyte leakage.

*Take care not to drop, dampen, disassemble the Remote Control Unit.

*Operatable remote control range is limited as shown.

OPERATING INSTRUCTIONS:

.

.

.

.

.

ANTENNA CONNECTIONS

Optimum colour reception requires a good antenna. An out-door antenna will be more effective to obtain a clear-picture.

Insert the out-door antenna into the antenna socket on the cabinet back. Adjust the direction or position for the best possible picture.

POWER SWITCH

Press POWER SWITCH, the appliance will be in operation mode.

The channel position number is displayed in the upper right corner of the screen for 4 seconds.

Press POWER SWITCH again to turn off the appliance’s power

CHANNEL SELECTION

Press CHANNEL SELECTOR ( ) on the appliance or the Remote Control Unit, the channel number will be increased or decreased as shown in the following Fig, and display in the upper right corner of the screen.

				CHANNEL INCREASE
CH		1	2		58		59			CH
		CHANNEL DECREASE
(REMOTE)	1			2		58		59	(THE APPLIANCE)

8

3