Panasonic AJ-D230H manual 4-1, 4-2

Operation
Recording
1
2
3
4
5
6
Set the accidental erasure prevention tab on the cassette tape to “recording,” and
insert the tape.
Press the STOP button to set the unit to the stop mode.
Check that the REC INH lamp is off.
Selecting the video and audio input signals and adjusting the audio signal level
4-1
Selecting the video and audio input signals
1 Connect the signals which are to be recorded.
2 Select the input signals using the INPUT SELECT switch on the front panel.
4-2
Adjusting the audio signal level
1 Adjust the audio input signal level.
The audio signals are recorded at the appropriate level when the level
controls are set to the center click-stop position.
Press the PLAY button while holding down the REC button.
The REC and PLAY lamps light, and recording is commenced.
To stop recording, press the STOP button.
Recording is now ended, and the unit is set to the stop mode.
<Notes>
A recording cannot be made properly on a tape on which the recording protection signal has
been recorded as an input signal.
During recording, check that the SERVO lamp is lighted. If the lamp is flashing or off, the
images played back will be disturbed.
14