Panasonic AJ-HD130DCP - page 25

25
<Notes>
OIf the PAGE button and the DATA+ or DATA– button are pressed together when menu item No.007
(CHARA H-POS) and No.008 (CHARA V-POS) are being set, the counter display appears temporarily
while these buttons are held down to enable the settings to be checked.
It is also possible to use the DATA+ button and DATA– button while holding down the PAGE button to
perform the settings while at the same time checking their actual status.
OEven when “OFF” is selected as the menu item No.005 (SUPER) setting, the superimposing is
displayed in accordance with the menu No.006 (DISPLAY SEL) setting while the menu settings are
being performed. When the menu setting process is exited, the display accords with the menu item
No.005 (SUPER) setting.
001 LOCAL ENA
0000
0001
0002
DIS
ST&EJ
ENA
For setting the buttons which can be operated on the front panel when the
LOCAL/MENU/REMOTE switch is at the REMOTE position.
0: No buttons can be operated.
1: Only the STOP and EJECT buttons can be operated.
2: All the buttons can be operated except for COUNTER and RESET.
002 TAPE TIMER 0000
0001 ±12h 24h
For setting the time system on the CTL counter display.
0: 12-hour system
1: 24-hour system
003 REMAIN SEL
0000
0001
0002
0003
OFF
2L
1L
R/TTL
For setting the superimposing of the remaining tape time and total tape
length displays for the VIDEO OUT2 connector.
0: No superimposed displays
1: Remaining tape time is displayed on the second line.
2: Remaining tape time is displayed on the first line.
3: Remaining tape time is displayed on the first line and the total tape
length on the second line.
<Notes>
OWhen “2L” has been selected as this item’s setting, the time will not be
displayed even if “TIME” was selected as the menu item No.006
(DISPLAY SEL) setting.
OEven when “R/TTL” has been selected as this item’s setting, the total
tape length will not be displayed if “TIME” has been selected as the
menu item No.006 (DISPLAY SEL) setting.
005 SUPER
0000
0001 OFF ON
For setting whether the displays are to be superimposed onto the VIDEO
OUT2 connector.
0: The displays are not superimposed.
1: The displays are superimposed.
006 DISPLAY SEL
0000
0001
0002
TIME
T&STA
T&S&M
For setting what displays are to be superimposed onto the VIDEO OUT2
connector.
0: Only the time display is superimposed.
1: The time and operation status are superimposed.
2: The time, operation status and mode are superimposed.
<Note>
When “T&S&M” has been selected as this item’s setting and a warning or
error occurs, an error message is superimposed.
007 CHARA H-POS 0000
::