- 9 -
Mounting Be sure to ask your store, where you purchased the
product, for mounting.
Disconnect the camera power connector before
mounting.
Before handling the card, touch a metal part of the
camera to discharge the static from the human body.
An anti-static wrist strap is recommended for added
safety.
If you touch the card while you are still charged with
static, it may cause trouble.
Keep the metal parts of the card free of contact with
other metal parts.
Caution 1 Switch the camera off, and disconnect the power
connector and other cables from the camera.
2 Loosen the four screws on the rear of the camera and
remove the rear panel.
3 Loosen the two screws for the option card slot and
remove the cover.
4 Insert the SDI card along the guide rail at the bottom of
the camera and the tab above. Insert it securely all the
way.
5 Tighten the two card setscrews securely.
If you have lost the screws, use the screws (6 mm long)
supplied as accessories.
6 Fasten the rear panel with the four screws.
If you have lost the screws, use the screws (Black, 8 mm
long) supplied as accessories.
7 Plug the cables back as necessary, connect the power
connector, then switch power on.