Reinstalling Software
28
Troubleshooting
zDo not interrupt the reinstallation procedure before completion, for
example by turning off the computer or pressing
Ctrl
+
Alt
+
Del
, as
this may prevent Windows from starting up, or may cause data to be
lost so that the reinstallation procedure cannot be executed.
JAfter the reinstallation procedure completes, the screen should appear.
Remove the Product Recovery DVD-ROM, and then press any key.
The computer will be shut down.
KTurn on the computer, and press
F2
while [Panasonic] boot screen is dis-
played.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Password.
LPress
F9
.
At the confirmation message, select [Yes] and then press
Enter
. (The
Setup Utility settings will return to their default values. Even the security
settings with the exception of the password(s) will return to their default
values.)
MSelect [Exit] and then select [Save Current Values], then press
Enter
.
At the confirmation messages, select [Yes] and press
Enter
.
NTurn the computer off by using the power switch.
zIf additional instructions are included with the computer, be sure to
read them. It may be necessary to perform additional operations during
the following procedures.
OPerform the first-time use operation. (Îpage 10)
PRun the Setup Utility and change the settings where necessary.

Changing the drive letter

You can change the drive letter for the CD/DVD drive or hard disk drive by the
following steps.
zDrive letters can only be changed when two or more partitions have been
created on the hard disk drive. The name of the C: drive cannot be
changed.
zWe recommend that you make these changes before installing applica-
tions.
ASelect [start] - [Control Panel] - [Performance and Maintenance] -
[Administrative Tools] - [Computer Management].
BSelect [Disk Management] from [Storage].
CRight click on the partition of the hard disk or the name of the CD/DVD
drive and select [Change Drive Letter and Paths...].
DSelect [Change].
ESelect [Assign the following drive letter] and the new drive letter, and then
select [OK].
FAt the confirmation message, select [Yes].