16 VQT1P98 VQT1P98 17

Preparations
1Charging battery
Always charge before first use! (not sold pre-charged)
Preparations
2Inserting battery and card
Approximate battery life
• Number of pictures : 300 [330 ] (at 30-sec intervals)
(equivalent to approx. 160 [165 2] mins)
1 Values based on CIPA standards. (P.99)
Number reduced if intervals longer – 75 [82 2] pictures if 2-minute intervals
• Playback time: Approx. 360 [380 ] mins
Above figures may be reduced if intervals between recordings are longer; if flash, zoom,
or LCD MODE are used frequently; or in colder climates (depends on actual usage).
2 DMC-TZ11
Battery will be warm during charging and for some time thereafter.
Battery will run out if not used for long periods of time, even after being charged.
Charge the battery with the charger indoors (10 °C-35 °C).
Do not disassemble or modify the charger.
If available battery power is significantly reduced, battery is reaching end of lifespan. Please
purchase a new battery.
The battery charger is in the standby condition when the AC power supply cord is connected.
The primary circuit is always "live" as long as the power cord is connected to an electrical outlet.
Frequently charging up battery is not recommended.
(Frequently charging battery reduces maximum usage time and can cause battery to expand.)
Always use genuine Panasonic batteries (CGA-S007E).
If you use other batteries, we cannot guarantee the quality of this product.
Do not remove card or battery while power is ‘ON’ or while status indicator is on
(Camera may cease operating correctly, or card/recorded contents may be damaged).
The reading/writing speed of a MultiMediaCard is slower than an SD memory card.
When a MultiMediaCard is used, the performance of certain features may be slightly
slower than advertised.
Keep the Memory Card out of reach of children to prevent swallowing.
Battery (check orientation)
Card (check orientation)
Do not touch terminal
Status indicator
1Set the camera ON/OFF switch to OFF
Slide to the ‘OPEN’ position
and open the lid
OPEN
LOCK
Release lever
2Completely insert battery
and card
(both click into place)
3Close lid
Slide to the ‘LOCK’ position.
SD memory card/
SDHC memory card (optional)
To remove
• To remove battery: • To remove card:
move lever in
direction of arrow. Lever press down in
centre.
Battery (model-specific)
Charging light (CHARGE)
On: Charging in progress (approx. 120 min.)
Off: Charging complete (Disconnect charger
and battery when charging is complete.)
If light is flashing:
• Charging may take longer than normal if
battery temperature is too high or too low
(charging may not be completed).
• Battery/charger connector is dirty. Clean with
dry a cloth.
Charger (model-specific)
1Insert the battery
terminals and attach
the battery to the
charger
Ensure ‘LUMIX’ faces
outwards.
2Connect the AC cord
The AC cord does not fit
entirely into the AC input
terminal. A gap will remain
as shown right.
3Detach the battery
after charging is
complete
After charging is completed,
be sure to disconnect the
AC mains lead from the
electrical outlet.