EH2331EU_01 04.11.30 14:37 ページ 4

Parts identification (Fig. 1)

FA Switch

FB Battery cover

FC Power indicator

FD Eyelash-base pad

FE Curling support

FEyelash-tip pad

Inserting the batteries (Fig. 2)

(Batteries sold separately)

1.Remove the battery cover.

2.Insert two AAA (LR03) alkaline batteries.

3.Replace the battery cover.

Make sure the batteries match the + and – markings.

Do not mix old and new batteries or use rechargeable batteries.

Remove the batteries when not using the product for a long time.

Using the eyelash curler

(Fig. 3)

1.Slide the switch upwards and hold it for about 15 seconds.

This allows the pads to heat up.

Pad surfaces will be between 40 and 45°C after about 15 seconds.

2.Slide the switch downward and place the curling support in contact with the base of the eyelashes.

3.Slide the switch upward slightly until the eyelash-base pad lightly holds the curling support.

If all eyelashes are not properly aligned between the pads, repeat steps 2 and 3.

4.Keep the switch sliding up so

4

that the tip pad holds the eyelash with the eyelash base, and hold it for 10 to 15 seconds.

Do not slide the switch up forcefully.

Q&A (Fig. 4)

Q1 Eyelashes are difficult to curl.

ATip 1: Make sure the switch is slid upward.

Tip 2: After applying for 15 seconds, slightly raise the end of the eyelash curler upward and hold for a few more seconds before sliding the switch downward.

Q2 Eyelashes at corners of eyes (eyelashes growing outward) are difficult to curl.

A Tilt the eyelash curler outward to properly align the outside eyelashes between the pads.

Use the edge of the eyelash curler.

Q3 Eyelash tips touch eyelids.

A Hold the eyelash curler closer to the face; do not raise the handle.

Q4 Eyelashes are long, making it difficult to curl tips.

A Clamp eyelash tips in the eyelash curler. Slide the switch upward slightly and use the eyelash-base pad to lightly curl eyelashes. If eyelashes are clamped at an angle, re-clamp them so they are straight.

Q5 What precautions should be taken when using the eyelash curler on eyelashes applied

with mascara?

A 1. Wait until mascara has completely dried.

2.Do not apply too much mascara, otherwise mascara may not dry and eyelashes may stick together.

3.If eyelashes stick together, comb them from base to tip to separate them.

4.Do not use the eyelash curler for a long time (max. 2 to 3 seconds).

Mascara may come off if the eyelash curler is used for a long time.

Caution

Keep out of reach of children.

Stop using the product if you notice anything abnormal about your eyes.

Persons with conjunctivitis or other eye illnesses should not use this product.

Do not use the product while wearing contact lenses.

If your eyes or eyelids feel unusual after applying mascara, stop using the product immediately.

Do not use the product if it has been dropped, struck or damaged.

Do not press the eyelash-base pad or eyelash-tip pad against your eyelids for long periods of time. There is a risk of burns.

Do not wash with water.

Do not modify, disassemble or repair.

If either pad comes in contact with your skin, causing a burning

5

sensation, use water to cool the area.

Consult a specialist if your eyes or eyelids feel unusual in any way while using the product or soon afterward.

If the product is dirty, dip a cloth in mild soapy water, wring it out, and then wipe the surface of the product. Do not use thinner or benzine.

If the curling support is dirty, use a soft tissue to lightly wipe off the surface.

The pads cannot be replaced. Do not pull them or remove them.

A damaged or defective product should be returned to a customer service center or an authorized customer service agent.

Do not attempt to use this product if defective or try to repair it yourself.

Specifications

Power supply: Batteries Battery size:

Two AAA (LR03) alkaline batteries (Sold separately)

Weight: 71g (including batteries)

Page 3
Image 3
Panasonic EH2331 Parts identification Fig, Inserting the batteries Fig, Using the eyelash curler, Specifications