3 DISASSEMBLY/ASSEMBLY INSTRUCTIONS
Ref. No. 1A Procedure 1A Removal and attachment of the Housings.
1. Loosen the belt hook bolt turningit counterclockwise, using a
coin or a flat blade screwdriver.
2. Take out the belt hook.
3. Remove nine housing screws.
4. Open the housing B.
NOTE :
The housing A and B is tightened as the motor mounting base
is joint fitting.
Hold the housing B andtake it out vertically.
5. Take out the fixation cover, protectors and anvil block.
(Removal)
NOTE :
When openingthe housings, make surethat the main PCB is
on the housing A.
If the main PCB sticks in the housing Band pullit out from the
housing A, the ribbon cable may be defected.
3
EY7540-U1/