4[O.I.S.] switch
When the lens is attached to the camera the stabilizer function is set to activate if the [O.I.S.] switch is set to [ON].
≥We recommend setting the [O.I.S.] switch to [OFF] when using a tripod.
≥The stabilizer function may not be effective in the following cases.
–When there is a lot of jitter.
–When the zoom magnification is high.
–When using the digital zoom.
–When taking pictures while following a moving subject.
–When the shutter speed becomes slower to take pictures indoors or in dark places.
5Contact point
6Lens fitting mark
Note
≥When flash recording with a close subject, the light of the flash will be blocked by the lens and part of the picture may be dark. Check the distance from the subject when recording.
Cautions for Use
∫About the Lens
Take care not to drop or knock the lens. Also take care not to put a lot of pressure on the lens.
≥Take care not to drop the bag that you inserted the lens in as it may damage the lens. The camera may stop operating normally and pictures may no longer be recorded.
When using pesticides and other volatile substances around the camera make sure that they do not get onto the lens.
≥If such substances get onto the lens they can damage the exterior case or cause the paint to peel.
Do not carry the unit when it is still attached to the camera body.
≥Under no circumstances should the unit be stored in any of the following locations since doing so may cause problems in operation or malfunctioning.
–In direct sunlight or on a beach in summer
–In locations with high temperatures and humidity levels or where the changes in temperature and humidity are acute
–In locations with high concentrations of sand, dust or dirt
–Where there is fire
9
VQT2C38
