Installation
Registering a handset to a base unit
1Handset:
Lift the handset and press MOFFN.
2Base unit:
Press and hold MLOCATORN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATORN again to stop, then repeat this step.
3Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and 
is displayed.
Note:
RIf an error tone sounds, or if 
is displayed, register the handset according to the base unit’s operating instructions.
Display language
1MMenuN (right soft key) #110
2MbN: Select the desired setting. a MSaveN a MOFFN
For your safety
To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product.
WARNING
Power connection
RCompletely insert the AC adaptor/power plug into the power outlet. Failure to do so may cause electric shock and/or excessive heat resulting in a fire.
RRegularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a fire.
RUnplug the product from power outlets if it emits smoke, an abnormal smell, or makes an unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped emitting and contact us at http://www.panasonic.com/contactinfo
4For assistance, please visit http://www.panasonic.com/help
