5 cm
6Things You Should Know NNN
Recharge
When the RECHARGE indicator flashes or the unit beeps
intermittently, place the handset on the base unit for about
9hours to recharge the battery.
Battery information
After your Panasonic battery is fully charged:
•The battery operating time may be shortened depending on usage
conditions and ambient temperature.
•As preventative maintenance, clean the handset and the base unit
charge contacts with a soft, dry cloth once a month. Clean more
often if the unit is subject to grease, dust or humidity. Otherwise
the battery may not charge properly.
•If the battery is fully charged, you do not have to place the handset on
the base unit until the RECHARGE indicator flashes. This will maximise
the battery life.
•The battery cannot be overcharged.
To replace the battery:
Press the notch on the cover firmly and slide it as indicated by
the arrow. Replace the old battery with new one (1-C). Close the
cover and charge for about 9 hours.
6-A Battery
Operation Operating time
While in use (TALK) Up to about 7 hours
While not in use (Standby) Up to about 120 hours
Battery replacement:
If you cleaned the charge contacts and fully charged the
battery, but after a few telephone calls, the RECHARGE
indicator flashes, the battery needs to be replaced. Replace the
battery with a new Panasonic P-P301 (KX-A36A) battery. See
section 1-C, step 3. When replacing the battery, programmed
information may be erased. Reprogram if necessary.
RECHARGE
Indicator
This unit can be mounted on a wall.
1Press the tabs in the direction of the arrows (1), then remove
the wall/desk stand (2).
2Connect the AC adaptor. Tuck the telephone line cord inside
the wall/desk stand, then push it in the direction of the arrows
(1 and 2).
•The word “UP WALL” should face upward.
3Connect the telephone line cord. Install screws using the wall
template below. Mount the unit, then slide down.
•Extend the antenna fully.
•Fasten the cords to prevent it from being disconnected.
6-B Wall Mounting
1 1
2
1
2
To Power
Outlet
For Australia
To Telephone Plug
and Socket
OR
For New Zealand
To Single-Line
Telephone Jack
Screws (not included)
Hooks
5 cm
Calls are transmitted between the base unit and the handset
using wireless radio waves. For maximum distance and noise-
free operation, we recommend the following:
Base unit
Power Supply: AC Adaptor (230 – 240 V AC,
50/60 Hz)
Power Consumption: Standby: Approx. 5 W
Maximum:Approx. 7 W
Frequency: 30 MHz – 39 MHz
Dimensions (H x W x D):
Approx. 90 mm x 125 mm x 210 mm
Mass (Weight): Approx. 260 g
Handset
Power Supply: Ni-Cd battery (3.6 V, 300 mAh)
Frequency: 30 MHz – 39 MHz
Dimensions (H x W x D): Approx. 260 mm x 55 mm x 45 mm
Mass (Weight): Approx. 170 g
Security Codes: 1,000,000
Operating Environment: 5 °C – 40 °C
Specifications are subject to change without notice.
6-CBase Unit Location
6-D Specifications
Away from electrical appliances
such as a TV, radio or
personal computer.
In a HIGH and CENTRAL
location with no obstructions
such as walls.
Extend
fully.