Panasonic KX-TG8200E/KX-TG8202E manual Frequently asked questions, Question Cause & solution

TG8200_8220E(e)_QG.fm Page 5 Wednesday, May 30, 2007 6:41 PM

Frequently asked questions

Question	Cause & solution
Why is w flashing?	LThe handset is too far from the base unit. Move
	closer.
	LThe base unit AC adaptor is not connected.
	Check the connections.
	LYou are using the handset or base unit in an area
	with high electrical interference. Place the
	handset and base unit away from interference
	sources, such as antennas and mobile phones.
	LThe handset is not registered to the base unit.
	Register it (page 7).
Why is the handset display	LThe handset is in screen saver mode. Press
blank?	{ih} to activate the handset display again.
What should I do when the	LMake sure that the batteries are installed
handset does not turn on?	correctly.
	LFully charge the batteries.
	LClean the charge contacts and charge again.
How long is the battery	LWhen you are using fully-charged Ni-MH batteries
operating time?	(supplied batteries);
	In continuous use: 12 hours max.
	In continuous standby mode: 150 hours max.
	LIt is normal for batteries not to reach full capacity
	at the initial charge. Maximum battery
	performance is reached after a few complete
	cycles of charge/discharge (use).
	LActual battery performance depends on a
	combination of how often the handset is in use
	and how often it is not in use (standby).
Can I keep the handset on	LEven after the handset is fully charged, the
the base unit or charger	handset can be left on the base unit or charger
when I am not using it?	without any ill effect on the batteries.
When should I replace the	LIf the batteries are fully charged until &is
batteries?	displayed, but )is displayed after a few calls,
	replace the batteries with new ones.
What is a PIN?	LThe PIN is a 4-digit number that must be entered
	in order to change certain base unit settings. The
	default PIN is “0000”.

– 5 –