4.6.Turntable motor
1.Remove the motor cover by breaking off at the 8 spots indicated by arrows with a cutter or the like.
NOTE:
After removing the motor cover, be sure that cut portions are properly trimmed or bent to the inside so that no sharp edges will be exposed to outside.
2.Disconnect 2 lead wires connected to the turntable motor.
3.Remove the turntable motor by removing screw.
NOTE:
After reinstalling the new turntable motor and reconnecting the 2 lead wires, reinstall the motor cover by rotating it around 180, tucking the 2 tabs under the base in the 2 provided slots, then screw the single tab to the base using a 4mm × 6mm screw.
4.7.Steam sensor
1.Disconnect connector CN2 from digital programmer circuit board.
2.Disengage catch hooks on sensor cover C from orifice.
3.Remove steam sensor from orifice.
NOTE:
When installing the steam sensor, make sure that the direction of steam sensor is as shown in figure.
12