11
Name and function of each remote control part
〈Remote control unit〉
STD (standard) button
This button is used to reset all of the projector adjustment values (BRIGHT,
CONTRAST, COLOR, TINT and SHARPNESS) to the default levels which were
set at the time of shipment from the factory. It is pressed after the respective
adjustment mode screen has been displayed.
SYSTEM SELECTOR button
This button is used to select RGB, RGB REALITY, or YPBPR(YCbCr)
signal or switch between video and digital-serial signal formats.
POWER button
This button is used to turn the projector power supply on and off.
•This button is enabled while the MAIN POWER switch is ON.
Input select buttons
These buttons are used to change the input between
INPUT 1 (slot 1)/INPUT 2 (slot 2)/INPUT 3 (slot 3).
If there are several input terminals in a single input slot, the
selection will change in order between all input terminals
available for that slot. (RGB button is invalid)
CONTRAST button
This button is used to select the mode for adjusting
the picture contrast.
BRIGHT buttons
This button is used to select the mode for adjusting the
picture brightness.
Numeric buttons
These buttons are used to specify this projector when it
is being used in a multi-screen projection system.
In addition, they are used to enter ID numbers when
selecting IDs, and to enter passwords.
PIC-MUTE button
This button is used to temporarily halt the projection
of a picture.
ON SCREEN button
This button is used to turn the on-screen display
function on and off.
NEXT button
If the ID SELECT button is being pressed and held, the tens
digit of the ID number then changes each time the NEXT
button is pressed.
ID SELECT button
When the projector is being used in a multi-screen
projection system, this button is used to select the mode
for specifying which projector is to be operated.
ID ALL button
When the projector is being used in a multi-
screen projection system, this button is used
to select the mode for controlling all
projectors using a single remote control unit.
LENS button
This button is used to select the mode for
adjusting the lens.