S P E C F I L E
Parameter format
Parameter format | Size (Byte) | Difinition | |
<pl> | 3 (1 or 2 bytes also | Dicimal without signs: | |
| possible when | Dicimal with signs: | |
| under control) |
| Callback from the projector is 3 Byte. |
<off on> | 1 | 0 | = off, 1 = on |
<input signal> | 3 | RG1 = computer 1, RG2 = computer 2, VID = video, SVD = | |
<installation> | 1 | 0 | = front, 1 = rear, 2 = ceiling and front, 3 = ceiling and rear |
<language> | 3 | ENG = English, DEU = German, FRA = French, ESP = Spanish, | |
|
| ITL = Italian, JPN = Japanese, CHI = Chinese, POR = Portuguese, | |
|
| SVE = Swedish, NOR = Norwegian, DAN = Danish, POL = Polish, | |
|
| CES = Czech, MAG = Hungarian, RUS = Russian, THA = Thai, KOR = Korean | |
<power condition> | 3 | 000 = power on (standby mode on), 001 = power off (standby mode off) | |
<lamp condition> | 1 | 0 | = standby, 1 = lamp on under control, 2 = lamp off, |
|
| 3 | = lamp off under control |
<acctch> | 4 | Dicimal without signs: | |
<lamp power> | 1 | 0 | = economy, 1 = normal |
<color temp> | 1 | 0 | = low, 1 = standard, 2 = high |
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.
Command example
To set the volume to +30, send the command as shown below.
STX | AVL : | 30 | ETX | ||||
|
|
|
|
|
|
| |
Start | Command | Parameter End | |||||
NOTE: When sending commands without parameters, a colon (:) is not necessary.
As of October 2008 |
| < 9 > |
