RS-232C Control Specifications PT-AE2000
Parameter format
Parameter format | Size (Byte) | Difinition |
| |
<off_on> | 1 | 0 | = off, 1 | = on |
|
|
| ||
<input signal> | 3 | VID = video, SVD = | ||
|
| CP2 = component 2, HD1 = HDMI 1, HD2 = HDMI 2, HD3 = HDMI 3 | ||
|
|
| ||
<power condition> | 3 | 000 = power on (standby mode on), 001 = power off (standby mode off) | ||
|
|
|
|
|
<off_timer> | 1 | 0 | = off, 1 | = 60 min, 2 = 90 min, 3 = 120 min, 4 = 150 min, 5 = 180 min, |
|
| 6 | = 210 min, 7 = 240 min | |
|
|
|
|
|
<x> | 1 | 0 | = off, 1 | = full scan (Y), 2 = full scan (R), 3 = full scan (G), 4 = full scan (B), |
|
| 5 | = single line (Y), 6 = single line (R), 7 = single line (G), 8 = single line (B) | |
|
|
|
|
|
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.
Command example
To set the volume to +30, send the command as shown below.
STX | AVL : | 30 | ETX | ||||
|
|
|
|
|
|
| |
Start | Command | Parameter End |
NOTE: When sending commands without parameters, a colon (:) is not necessary.
As of October 2007 |
| < 4 > |