ENGLISH - 41
Settings
PROJECTOR SETUP menu
You can see the status of the projector about the
following items.
You can switch the function of the COMPUTER2 IN/
1OUT terminal.
INPUT COMPUTER2 IN
OUTPUT COMPUTER1 OUT
You can set the timer to switch off the power of the
projector after a certain period of time automatically
when no signal is detected. Press I H to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
You can select how the projector start when the power
cord is connected.

STATUS

Items Description

QSIGNAL

NAME Projecting signal name
FREQUENCY Projecting signal frequency

QRUNTIME

PROJECTOR Duration of projector used time
LAMP Duration of lamp used time

QREMAINING FILTER

QUANTITY Quantity of filter remaining
APPROX.TIME Approximately time of filter
remaining
NOTE:
•QUANTITY and APPROX.TIME of REMAINING
FILTER is not the accurate but the calculated and
predicted result based on the filter rolling pace.
Incorrect remaining time could be displayed briefly;
such as suddenly shortened or stays same for a while.
• Replacement of the Auto Cleaning Filter (ACF) needs
to be prepared when the QUANTITY and
APPROX.TIME of REMAINING FILTER becomes few.
Remote control Control panel
See “Navigating through the menu” on page 32.
See “Main menu and Sub-menu” on page 30.

COMPUTER2 SELECT

NO SIGNAL SHUT-OFF

DISABLE
FG FG
15 MIN. 60 MIN.
FG FG
20 MIN. 55 MIN.
FG FG
25 MIN. 50 MIN.
FG FG
30 MIN. 45 MIN.
FG FG
35 MIN. IH 40 MIN.

INITIAL START UP

Options Description
LAST MEMORY Start as the same mode as the
last switched off.
STANDBY Always start in standby mode.
ON Always start in projecting
mode.