Panasonic SL-SX293, SL-SX290 operating instructions Sequential Play

Sequential Play

Basic Play

	5	Increase
		VOL	VOL
4			C S-XBSTRAIN
		VOL	ALL1 M
			RANDOM
			SORRY
	Track number in play	Decrease
	VOL
	C S-XBSTRAIN		O
	ALL1 M
			P
	RANDOM		R
	SORRY		O
			F
			F

Elapsed playing time of each track

1 OPEN

3 HOLD

Plug type:

3.5 mm (1/8 in.) stereo

Label must face upward.

2

Close the lid.

R L

Follow steps 1–5.

In step 2: Connect the stereo headphones to the headphone jack [Ë].(Plug in firmly.)

In step 5: The volume range is 0-25. Press and hold to change the volume successively. The volume changes when pressed while the level is displayed. If any other display is shown, it changes to show the current level. (The volume returns to 10 when you disconnect the power source.)

≥Play stops automatically when all the tracks have been played.

≥If the unit has been connected to the car audio system, set this unit’s volume to 10, then adjust the volume level on the system.

For your reference: “)” indication

This indication appears for about 30 seconds if [1;] is pressed when no disc is loaded in the unit or if the disc is not properly secured.

“*” indication

This indication appears for about 10 minutes when the cover is opened. (However, the indication does not ap- pear when the unit is powered off.)

Operation

To pause play

To stop play

Stop mode

To turn off the

Button			Display/reference
Press during play.			Press again to restart play.
			VOL
			C S-XBSTRAIN
			ALL1 M
Press during play.			Total number of tracks
	O
	P
	R
Resume function	O		VOL
	F
		F
Play starts from the beginning of			ALL1 M
			C S-XBSTRAIN
the current track the next time you			Total playing time
press [1;].
Press during stop mode.			No indicator is shown.

Removing discs

1Press [∫, OPR OFF] to stop play and disc rotation.

2Slide [OPEN 1] to open the lid.

3Press [PUSH] to release the disc.

Do not stop the disc by hand or try to remove it before it stops rotating. This can damage CDs.

HSUP

PUSH

Note!

unit Off mode

Skip forward/

backward

(skip function)

Rapid forward/

backward

(search function)

O
P
R
O
F
	F

The resume function remains active.

Press during play.

(Press [:] twice to skip to the beginning of the previous tracks.)

Backward

Forward

Press and hold during play.

VOL

C S-XBSTRAIN

ALL1 M

≥During program play (page 4), these buttons are used to skip forward or backward through the programmed sequence of tracks.

≥You cannot skip to tracks that have been played in random or random repeat play (page 4).

≥During program play, 1-track repeat play, random play and random repeat play (page 4), search op- eration is limited to the current track only.

Never insert foreign objects into the unit.

Auto power off function

If the unit is left in stop mode for approximately 10 min- utes, the unit powers itself off automatically in order to prevent the battery from running down.

(If no disc is loaded in the unit, it powers itself off in about 30 seconds.)

Note on CD-R and CD-RW

This unit can play CD-DA format audio CD-R and CD-RW that have been finalized§ upon completion of recording. It may not be able to play some CD-R or CD-RW due to the condition of the recording.

Resume function notes

≥Opening the lid while in the stop mode or replacing the disc while in the off mode cancels the function. (It may re- main active if you replace a disc in the off mode.)

≥Play may resume from the beginning of the next track if you stopped play near the end of a track. ≥The resume function works automatically and cannot be turned off.

§Finalizing is a process that enables CD-R/CD-RW players to play audio CD-R and CD-RW.

3