Panasonic TC-L22X2 Safety Precautions, Secure Ventilation, Important Safety Instructions

Safety Precautions

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING: To reduce the risk of electric shock, do not remove cover or back. No user-serviceable parts inside. Refer servicing to qualified service personnel.

The lightning flash with arrowhead within a triangle is intended to tell the user that parts inside the product are a risk of electric shock to persons.

The exclamation point within a triangle is intended to tell the user that important operating and servicing instructions are in the papers with the appliance.

Note to CATV System Installer

This reminder is provided to direct the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Secure Ventilation

Slots and openings in the cabinet and the back or bottom are provided for ventilation, and to ensure reliable operation of the LCD TV and to protect it from overheating. These openings must not be blocked or covered. There should be at least 10 cm of space from these openings. The openings should never be blocked by placing the LCD TV on a bed, sofa, rug or other similar surface. This LCD TV should not be placed in a built-in installation such as a bookcase unless proper ventilation is provided.

Important Safety Instructions

1)Read these instructions.

2)Keep these instructions.

3)Heed all warnings.

4)Follow all instructions.

5)Do not use this apparatus near water.

6)Clean only with dry cloth.

7)Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8)Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9)Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10)Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11) Only use attachments / accessories specified by the manufacturer.

12) Use only with the cart, stand, tripod, bracket or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over.

13)Unplug this apparatus during lightning storms or when unused for long periods of time.

14)Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15)Operate only from the type of power source indicated on the marking label. If you are not sure of the type of power supplied to your home consult your television dealer or local power

company.	EXAMPLE OF ANTENNA
16) Follow all warnings and instructions marked on the LCD TV.	GROUNDING AS PER
17) Never push objects of any kind into this LCD TV through cabinet	(NEC) NATIONAL			ANTENNA
slots as they may touch dangerous voltage points or short out	ELECTRICAL
	CODE			LEAD-IN WIRE
parts that could result in a fire or electric shock. Never spill liquid
	GROUND CLAMP
of any kind on the LCD TV.				ANTENNA
18) If an outside antenna is connected to the television equipment,
be sure the antenna system is grounded so as to provide some	ELECTRIC			DISCHARGE UNIT
				(NEC SECTION 810-20)
protection against voltage surges and built up static charges.	SERVICE
				GROUNDING
In the U.S. Section 810-21 of the National Electrical Code	EQUIPMENT
provides information with respect to proper grounding of the mast				CONDUCTORS
				(NEC SECTION 810-21)
and supporting structure, grounding of the lead-in wire to an
			GROUND CLAMPS
antenna discharge unit, size of grounding conductors, location of
		POWER SERVICE GROUNDING
antenna discharge unit, connection to grounding electrodes, and
		ELECTRODE SYSTEM
requirements for the grounding electrode.
		(NEC ART 250, PART H)

4