■Assembling the pedestal
Insert the protrusion of the Neck into the Base firmly.
Attaching the pedestal to TV
Turn the stand over and fix stand neck securely with assembly screws.
(for 50”: 3 screws, for 55”: 4 screws)
•Do not hold the neck when turning over the stand.
Accessories
Assembly screws
A
Neck
Protrusion of the
Neck (bottom)
Front
Front
Back of Stand
Bx 3 pcs. (for 50”) B x 4 pcs. (for 55”)
Hole for screw
XYN4+F10FNK (Black) size (M4 x 10)
(for 50” (5), for 55” (1))
B
XYN5+F16FN (silver)
size (M5 x 16)
(for 50” (7), for 55” (12))
Bracket (1) 
TBL5ZA3254 (for 50”)
TBL5ZA3200 (for 55”)
Attach the Bracket to the protrusion of Neck. Make sure that the bracket is anchored before fixing the screws.
Fix securely with assembly screws. (4 screws)
Protrusion of Neck (top) | B x 4 pcs. |
Bracket
Attach the cover and fix securely with assembly screw.
A x 1 pcs.
Cover
Neck (1)
TXFBL5Z0083 (for 50”)
TXFBL5Z0086 (for 55”)
Cover (1)
TXFBL5Z0091 (for 50”)
■Set-up
Tighten assembly screws 
(total 4 screws) loosely at first, then tighten them firmly to fix securely.
Rear side
TXFBL5Z0056 (for 55”)
Cover is in the same bag with Owner’s Manual
Base (1)
TBL5ZX0313 (for 50”) 
TBL5ZX0328 (for 55”)
Arrow mark
Hole for pedestal installation
A | x 4 pcs. (for 50”) |
B | x 4 pcs. (for 55”) |
Bracket
Base 
(Image) Work on a flat surface
Warning
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall hanging bracket or repacking the TV.
Remove the assembly screws 
(for 50”)/
(for 55”) from the TV.
Lift the TV from the pedestal.
Remove the assembly screw 
from the cover.
Pull out the cover.
Remove the assembly screws 
from the Bracket. 
Remove the assembly screws 
from the Back of stand and pull out the neck.
Do not disassemble or modify the pedestal.
Otherwise, the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than that provided with this TV.
Otherwise, the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately. |
|
During |
|
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong |
|
enough to support the TV, and it might fall over and become damaged, and personal injury may result. |
|
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (Above) |
|
Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result. | 9 |
|
